真人作爱试看50分钟3分钟

    <noframes id="nf9xx"><address id="nf9xx"></address>
    <form id="nf9xx"><nobr id="nf9xx"><progress id="nf9xx"></progress></nobr></form>

           Home   Contact Us   Download   中文版
          Search:
          Home About Us News Products Solutions Download Feedback Contact Security check
          Company News
          Industry News
          Social News
          Add: Chaoyang District Wangjing Beijing garden building 25, 6032
          Tel: 400-827-8891
          Fax: 0755-27168600
          Email: hycuishilong@foxmail.com
          SiteUrl: http://www.nyc-daily-photo.com
          Your Current Location:Home > Company News
          Technical Requirements for Shante UPS Parallel Connection
          Time:2019-08-01    Source:    Views:1896
          Unlike DC converter power supply, Shante UPS power supply outputs sinusoidal wave. When parallel power supply is connected, the amplitude and phase angle of output voltage need to be controlled simultaneously, that is to say, it must operate at the same frequency, phase and amplitude. From the analysis of the basic principle of Shante UPS uninterruptible power supply parallel connection, it can be seen that if the output voltage amplitude or phase of each UPS power supply module is inconsistent, there will be active and reactive circulations between different modules; and that the modules operate at the same frequency, phase and amplitude, if the output voltage harmonics of each module contain. In large quantities, harmonic circulations will exist between the modules. As a result of serious accidents, the safe parallel operation of inverters needs to meet the following conditions.
          1) Power equalization: The output voltage frequency, phase, amplitude, waveform and phase sequence of each inverter module in parallel system are basically the same. Each module shares load current equally, so that the output static power and instantaneous power distribution are balanced.
          2) Automatic fault diagnosis: When the module fails, the parallel system can locate the fault inverters quickly, remove them from the parallel system, and distribute their power evenly to other modules.
          3) Hot swap: When the difference of frequency, phase, amplitude and phase sequence between the output voltage and the parallel system voltage is less than the allowable error, the parallel system will be put into operation automatically, and the impact on the parallel system will be small. When any module fails or needs to be repaired, it can exit the parallel system online without power failure.
          LinkUrl:
          Add:Chaoyang District Wangjing Beijing garden building 25, 6032  Tel:400-827-8891    
          CopyRight ? 2021 Beijing Hengsheng Tengda science and Technology Co. Ltd.  All rights reserved  粵ICP備11063008號 -1
          真人作爱试看50分钟3分钟
            <noframes id="nf9xx"><address id="nf9xx"></address>
            <form id="nf9xx"><nobr id="nf9xx"><progress id="nf9xx"></progress></nobr></form>